I bought a new bong today after loaning my regular one to a friend who broke there’s but upon getting it home I realized that it was like nothing I’ve seen before. It has two chambers separated in the middle by two handle like tubes that connect the chambers but in between that there’s two holes and it confuses me badly. So if that didn’t make sense- basically at the bottom of the top chamber there is a hole about the size of a bowl’s hole, and then directly below it at the top of the bottom chamber there’s another hole exactly the same. The bottom chamber has a honeycomb and when I fill it up how I would with a normal honeycomb it doesn’t pull right at all and if I put water in through the top it goes right through the holes into the bottom chamber. I’m completely at a loss really hoping one of u great people will be able to help. I’ll post pictures up later on when I get home if that would help. TLDR, please help me figure out my bongs weird holes I really wanna bong rip :/
Wow thank you guys I’m sorry I didn’t get any relplies last I checked last night so I never uploaded pictures I made the drawing while I was posting haha- but what I’ve done so far is exactly what the bottom comment said I plugged the bottom hole with a clean cig filter and the top one with my finger and it works but still doesn’t seem right- will post pictures of the actual bong momentarily thanks everyone
I'm assuming (given that all I have to go off is this drawing and not an actual picture) the part that says "holes about bowl size" is some kind of perc? So just fill that separately from the top and fill the other part from the area where the bowl goes.
Probably so we all can think of ways how the bong would work when in reality with his drawing that shit ain’t going to work Sent from my iPhone using Grasscity Forum
