Here she is: Can put ice on top of the perc and it's pretty much a catch. Step by step on how I made her: First: SUPPLIES NEEDED: 2 gatorade bottles (or any other 2 bottles, same size), 1 cap, 1 lid to a shaving cream bottle or smaller bottle (not as wide as your bottles and relatively short), relatively thick tubing or a large pen, not too big to put through the cap, electrical tape, hot glue (optional, but very recommended), paper clip, lighter. Get two gatorade bottles Keep one of the lids Clean them out througholy in hot water with soap etc. etc. Cut the bottom of one off (most gatorade bottles have an indentation near the bottom which is a perfect place to cut Tape around the bottom of the cut bottle just to make the plastic "not sharp" Use one bottle as the bottom (we'll call it bottle 1) Use a bottle cap on bottle 1 and make a hole in it big enough for your larger tube (large pen such as sharpie, highlighter, or rubber tubing) Jam in the tube through the cap, make it air tight with tape or hot glue or something, whatever. Screw the cap onto bottle 1 and tape around it for good measure Next, take your small bottle, or lid. Light the paperclip for a while until it's hot then drill a bunch of tiny holes near the bottom of it and fit it on top of the cap and the tube. Make sure this is not wider than bottle 1 or bottle 2. Seal on the smaller bottle or lid to bottle 1 and make sure they're air tight. Next, put bottle 2 on top of bottle 1, covering the smaller bottle or lid and then tape/glue it on. To make a downstem/bowl set up, I'm sure you can find that anywhere.
Haha I don't know why, but seeing a nicely made homemade bong milked is much more satisfying than seeing milked glass.
[quote name='"noviceGrower420"']So jealous!![/quote] Of that? LOL, fair effort to op home made percs are pretty hard to make good and airtight