I was wondering if anyone has tried this, or something similar to it: Easy To Make Home Made Bong Video If so, first of all, does it work? How high does it get you? And how much water do you initially fill the bottle with? Any help would be greatly appreciated.
yes that is a gravity bong, the most reliable smoking device to get you plastered, you could use .4 in a bottle like that and get ripped. fill da botttlle upp full
Thanks but what I don't understand is the bowl. Where does the weed go and how does the smoke fill the bottle?
you could prolly just use a socket that you use with socket wrenches. Put in some sort of screen and stick the ganj right in there
The water constantly flowing out of the bottle lights the weed and pulls it into the bottle. When i make one though i carve a hole in the top of the bottle and put a wrench socket in as the bowl
yeah this is what i do, i have a socket and a shoved a screen in it and filled resin in it so i dont have to worry about the screen falling out when i cash it.
the best bottle for this, i've found, is a glass sobe bottle because it has a notch at the bottom where if u take a drill bit or something like that and gently tap it with a hammer at that notch it pops a perfect hole in the bottom of the bottle. socket on top and ur good to go. no plastic, no aluminum foil
Best way to make a Gravity Bong. You need: -2 liter bottle or larger -5 gallon bucket, or anything else that fits a 2 liter bottle. -A knife -a blunt (slides will work too.) -ping pong ball (optional) Step 1: Roll blunt first with swisher, or whichever blunt is your favorite, set aside. Fill bucket up with water. Cut the bottom off of the 2 liter bottle. With a full bucket of water, keep the cap on the bottle and push the bottom down into the water to the cap. You do this so you can displace 2 liters of water. SCIENCE! Step 2: Take your sharp pointed knife, steel pocket knifes work best, and start poking a hole in the middle of the cap. After you get a little hole you just start twisting the knife til you get the hole about the size of the blunt you rolled. Periodically check, the blunt should fit very snug and should not fall through at all. (Note: I usually take out the blue plastic on the bottom side of the cap.) Step 3: After you have inserted the blunt into the top of the cap it's time to start pulling out some hits! Put the ping pong ball you might have into the bucket and put the bottle over it and press it down letting all the air out til the ball hits the top of the bottle and won't raise anymore. Light blunt and twist cap on (or put cap on and insert slide.) It doesn't have to be tight, just tight enough air won't pull through. Now start raising the bottle slowly, pulling it as far out of the water without letting the smoke inside out. The water level will try to be at equilibrium, so when you raise the bottle out of the water it creates a vacuum inside the bottle by gravity pulling down on the water. Hence why we call it a gravity bong. MORE SCIENCE! Step 4: The hit! Now here is the PROPER way it should be taken. Now, take a deep breath and breathe it out, take the cap off (or put out slide) and put your sweet lips up to this. With your airway closed push the bottle back down into the water until water is just in front of your face. Now open your airway up and inhale (Be careful if you don't have a ping pong ball, you can inhale water. Think dummies! I can't count how many times I have seen this and laughed.) You do it this way cause gravity, yet again, works to our advantage at doing all the hard work. The higher water level surrounding the bottle is pulled down and fills into the bottle creating pressure, forcing the hit into you. All because water wants to be at an equilibrium. THANK YOU HIGH SCHOOL PHYSICS! I swear you taught me a new way to smoke every week.
