Try JB weld instead of glue, you can get it at any home improvement store, possible wally world. That should hold a nail/screw head to the top of the dime, just clean it off with alcohol first and once the JB weld is dry pull it out.
UPDATE, still stuck! I put it in the freezer upside down for hours, put it upside down and blew through it, hit it might metal spoons, the motherfucker is really lodged in there! Ima have to try the JB weld, the air pressure, and whatever else I can haha fuck!
Should be around 5-6 bucks. Might be a little steep to just get a dime out, but better than scrapping the bong.
Go get a bicycle pump, stick the hose in put some electrical tape all around it and pump like a motherfucker. If it leaks air around the dime, fill it with water and do it again. Worst case scenario go to your local Harbor Freight and buy a cheap rotary tool with a high speed bit...prolly around $25 for all of it, and drill it. Use light pressure, and a steady hand. Good luck man...JB weld is gonna be like 5 bucks a pack...but it won't stick to a flat surface like that with the amount of pressure you'll need to apply. This is going to take some mechanical action.
N why the fuck would a dime tell you the joint size? It's not fucking hard to determine what size your shit is by lookin at it..
You shouldn't have used the freezer, cold contracts things. Try what I do when my down stem gets stuck, very hot water poured over the stem. Put some WD 40 or butter or whatever you have around the dime, then hold it upside down, heat it with water or a small torch and give it some light taps, hopefully it will fall out.
Myth busters lifted a car with like 3 drops of super glue. The guy on the package glued himself to the roof. Prep your surfaces and pull the nail straight and I am very certain that dime will be free. Why do u want that dime so bad anyway? R u that broke?
HAHAHAHA THATS THE FUNNYEST THING IV EVER SEEN LMAO... THERE ARE ONLY 2 SIZES AND YOU NEED TO STICK A DIME IN IT TO FIND OUT WHAT?!?!? LOL
Ill have to try that to, thanks for all the help man much appreciated. Ok I guess I wont try the JB weld then
