Actually...filling it with water, then taking a wad of saran wrap around a wand of paper towels...make a hydraulic piston...shove it in there and pump it. That may work......Only a fucking stoner could do this.
I guess ill try the freezer method, thats pretty much my last choice. Ive even tryied gorilla gluing a nail to it and pulling it, just broke off
try boiling water and pour it down the mouthpiece, then use a thin knife, stick it through an edge of the penny and pry it out Sent from my iPhone.
Did holding upside down and tapping the joint not work? Sent from my MB886 using Grasscity Forum mobile app
Of course it did. Gorilla glue is a wood glue man. I think holding the piece upside down and tapping with a wooden spoon around the sides of the joint where the dime is will eventually vibrate it out. But it would likely take a while.
Put your mouth on the piece right above the dime and suck that bitch out lol don't know if it will work but hey worth a try
get a high pressure air pump (for refilling tires) and put it in the mouth piece, should build up enough pressure to blow it out
3 other bongs and you couldnt figure out the size of your joint? C'mon man!!!! haha tap that fucker out
If its not too far you may get somebody to gas weld a copper wire to it and pull it out. some wire and a welder to stick the electrodes to it and yank it out.
