By meisterpa at 2012-02-11 The 2'6" "PokeBong" What are your thoughts? This is just a prototype... The duct-tape will be an o-ring type fitting... Would you buy something like this and at what price? Remember... The actual product will be a lot cleaner and no tape will be used... It also breaks down.. you can disconnect the chamber by just pulling on it. Then there is a cap for the hole.
Once again this isn't even close to what the final project will look like... Please link me to it? Thanks!
The downstem should be placed on the ball instead if the bore because your gonna have to put a shit ton of water in that thing.
I think it's pretty cool. There's going to be a lot of people complaining about plastic and tape, just a heads up
i was going to say find a sphere based bong like these and just paint them. which looks like what these people did. but those look ceramic? i'm not a fan of ceramic so i'd just get a glass one to paint anad put the slide up higher instead of at a 90 degree angle like that one.
[quote name='"MeisterPA"'] Once again this isn't even close to what the final project will look like... Please link me to it? Thanks![/quote] I remember seeing it on here. The white button near the center was where the downstem/bowl goes, and the water was inside the pokeball itself. I'd happily link you to it, however i saw it on here a while back when i was faded.
Yes, it's just painted. Would you rather smoke from a cheap chinese manufactured plastic childrens toy?
